The 'Yellow' line of tooling is designed specifically for cutting stainless steel alloys.
The 'Brawler' line is designed for aggressive roughing and machine tools capable of spindle speeds up to 20K rpm. It incorporates our proprietary flute surface treatment producing a high lubricity finish specially optimized to handle a wide variety of cutting conditions and our special blend of fully variable geometry (including helix, pitch, spacing, location and size) as well as aggressive chip breakers designed to reduce chip size. This line of cutting tools is not designed to produce finish surfaces, but rather to achieve maximum material removal rates while still leaving a relatively smooth surface.
'N' form tools are simple corner-chamfered end mills. These are very similar to 'R' but with a chamfer instead of a radius. Note that square/flat end mills are classified under the 'R' form only.
|Material||Stainless Steel||Application||Rough 3D Milling <20k RPM (Brawler)|
|Form||Chamfered End Mill|
|Cutting Diameter||0.1181"||3.000 mm|
|Corner Size (45 deg.)||0.0059"||0.150 mm|
|Taper per Side||0.0°|
|Length of Cut||0.4724"||12.000 mm|
|Minimum Extension||1.0"||25.4 mm|
|Maximum Extension||2.1"||54.0 mm|
|Shank Diameter h6||0.2500"||6.350 mm|
|Overall Length||2.0"||51 mm|
|Cutting Parameters - Flank Roughing @10K|
|Tool Extension (Stickout)||1.0000"||25.400 mm|
|Step Over (Radial, Ae)||0.0197"||0.500 mm|
|Step Down (Axial, Ap)||0.3937"||10.000 mm|
|Spindle Speed (S)||10000 RPM|
|Feed Rate (F)||20 in/min||500 mm/min|
|Cutting Speed (Vc)||309 ft/min||94 m/min|
|Mat. Removal Rate (MRR):||0.15 in³/min||2.5 cm³/min|