Description
The 'Purple' line of tooling is designed specifically for cutting wrought titanium alloys.
The 'Feeder' line is designed for aggressive feed-mill roughing. This line of cutting tools is not designed to produce finish surfaces, but rather to achieve maximum material removal rates using the entire face of the tool and a relatively shallow depth of cut per pass combined with high feed rates and a special profile which takes advantage of axial chip thinning.
'F' form tools are intended for feed-milling; shallow cutting at high feed. They have back-relieved flanks and are not intended to be used to cut past their widest point.
Tool Properties | ||
---|---|---|
Name | PURFEEDER-3.000F0.03-13.0HUM16.0-G25AB1 (0682365) | |
EDP # | 0682365 | |
Material | Titanium | Application | Rough Feed Millling (Feeder) |
Form | Feed Mill | |
Cutting Diameter | 0.1181" | 3.000 mm |
Equivalent Corner Rad | 0.0012" | 0.030 mm |
Taper per Side | 0.0° | |
Length of Cut | 0.0142" | 0.360 mm |
Reach | 0.5118" | 13.000 mm |
Minimum Extension | 0.6" | 16.0 mm |
Maximum Extension | 2.1" | 54.0 mm |
Shank Diameter h6 | 0.2500" | 6.350 mm |
Overall Length | 2.5" | 63 mm |
Cutting Edges | 2 |
Cutting Parameters - Feed Milling @10.2K | ||
Coolant | Low Pressure | |
Tool Extension (Stickout) | 1.0000" | 25.400 mm |
Step Over (Radial, Ae) | 0.0906" | 2.300 mm |
Step Down (Axial, Ap) | 0.0059" | 0.150 mm |
Spindle Speed (S) | 10200 RPM | |
Feed Rate (F) | 49 in/min | 1250 mm/min |
Cutting Speed (Vc) | 315 ft/min | 96 m/min |