The 'Purple' line of tooling is designed specifically for cutting wrought titanium alloys.
The 'Pointer' line is a tight-tolerance 3D point/ball finishing tool which uses only the tip of the tool for cutting. This line is intended for machine tools with spindles capable of speeds up to 20K rpm.
'R' form tools are the classic end-mill shape, straight sides (flanks) with corners ranging from sharp (flat tip) to completely round (ball tip). This form is the most common of all, and good for almost everything.
|Application||Finish 3D Point Milling >20k RPM (Pointer)|
|Form||End Mill - Ball|
|Cutting Diameter||0.2500"||6.350 mm|
|Corner Radius||0.1252"||3.180 mm|
|Taper per Side||0.0°|
|Length of Cut||0.2500"||6.350 mm|
|Minimum Extension||0.5"||12.7 mm|
|Maximum Extension||1.6"||41.3 mm|
|Shank Diameter h6||0.2500"||6.350 mm|
|Overall Length||2.0"||51 mm|
|Cutting Parameters - Fine Point Milling|
|Tool Extension (Stickout)||0.5000"||12.700 mm|
|Step Over (Radial, Ae)||0.0050"||0.127 mm|
|Step Down (Axial, Ap)||0.0020"||0.051 mm|
|Spindle Speed (S)||12222 RPM|
|Feed Rate (F)||48 in/min||1218 mm/min|
|Cutting Speed (Vc)||800 ft/min||